As we all know, the four-in-one gas detector is the 1 gas detector that can continuously detect 4 kinds of gases at the same time, such as simultaneously detecting combustible gas, oxygen, carbon monoxide, and hydrogen sulfide. Each gas concentration reading is displayed on the LCD display. When the detection result exceeds the preset alarm setting value, the four-in-one gas detector can remind the user through sound, light and vibration alarms. It is precisely because the four-in-one gas detector is very important to us, we must control the correct installation method when installing. Do you know how to install 4-in -1 gas detector ? The following is a brief introduction by yi yun Tian:

four-in-one gas detector installation method:

1. installation steps:

1. Select the installation location of the four-in-one gas detector.

2. Wiring.

3. Communication test between the four-in-one gas detector and the control room.

4. Charge and test the gas detector.

5. Installation of the four-in-one gas detector.

Precautions for 2. installation:

1. The installation should be operated by personnel with relevant explosion-proof installation qualification certificates.

2. During the installation process, if you have any questions, please contact the manufacturer in time for technical support.

3. The four-in-one gas detector must be placed in a non-dangerous place without explosive gas mixtures. Please install the four-in-one gas detector in a ventilated and dry place to avoid direct sunlight, dust and vibration. When the tester is working, it is strictly forbidden to shake or wipe with a damp cloth.

4. Wall-mounted installation and fastening expansion bolts are appropriate. When installing, leave a gap of 100mm on the left and right sides of the four-in-one gas detector, and leave enough space for the wiring below.

5. Before installation, please check and make sure that the tester is in good condition and the accessories are completed. If you have any questions, please contact the supplier.

6. The cable wiring should eliminate the influence of electromagnetic interference as much as possible. The distributed capacitance of the cable is less than 1,0 μF, and the distributed inductance is less than 1mh.

7. Users are not allowed to replace the parts of the four-in-one gas detector without authorization, which will affect the performance of the product. In case of failure, it should be solved together with the product manufacturer in time to prevent the occurrence of safety accidents.

8. The installation, use and maintenance of the product shall strictly abide by the instructions for use and relevant standards, otherwise the consequences shall be borne by oneself.

In summary, it is the installation method of the four-in-one gas detector. It is worth noting that during the installation of the four-in-one gas detector, improper operation will cause serious consequences. Therefore, during the installation process, it must be standardized to avoid damage to the four-in-one gas detector.