Nowadays, one of the focus issues in the operation of industrial enterprises is environmental safety protection and industrial management quality. If enterprises want to create a better construction environment and industrial operation conditions that make employees more happy, it is very necessary to install gas detectors to realize accurate monitoring of hazardous gases. However, after gas detector has been used for a long period of time, in order to ensure the criterion of the test results, it is very important to do a good job in the maintenance and maintenance of the gas detector. So do you know the maintenance and maintenance methods of the gas detector? The following staff to share with you.

gas detector maintenance and maintenance methods:

1. Keep away from moisture, rain and corrosive liquids to ensure that the surface of the instrument is clean and dry. Do a good job of cleaning, to ensure that the surrounding environment is also clean and tidy. When cleaning and wiping, wipe gently with soft cotton cloth dipped in water, and remember to dry in time. Do not use chemicals, detergents, large concentrations of detergent to clean.

2. Take off the filter and clean it with a soft clean brush and clean warm water. The strainer shall be in a dry condition before it is put on again.

3. pay attention to regular calibration and testing: toxic and harmful gas detectors, like other analytical and testing instruments, are measured by relatively comparative methods.Therefore, it is necessary to calibrate the instrument at any time and to calibrate the instrument regularly to ensure the accuracy of the instrument measurement.

4. check whether there is air leakage in the gas path system, whether the diaphragm of the sobbing pump is damaged, whether the sealing ring of the sampling probe is broken, and whether the four-way valve and condensate steam are damaged.

the above maintenance of the gas detector is shared here. the maintenance is to make the gas detector monitor the gas environment for factories and enterprises longer and more accurately, and to protect the life safety of operators and the property safety of the factory at all times.