Ozone, as the 1 kind of light blue gas with fishy smell at normal temperature and pressure, has strong oxidation and can kill bacteria, viruses and other microorganisms, but at the same time, it is also 1 1 toxic strong oxidant. A certain concentration of the gas can cause headache, dry throat, respiratory tract damage, and even endanger personal health. Therefore, many enterprises now have to install ozone gas detectors in some operating environments. Then Ozone Gas Detector What should I pay attention to when installing? The following is a brief introduction by yi yun Tian:

ozone gas detector installation precautions:

1. the leak point or detection point is the location where ozone gas exists. the closer the better, because ozone is chemically active and easily decomposed.

2. the installation height of the ozone detector should be lower than the leak point, because the molecular weight of ozone is larger than that of air, and ozone will diffuse below the leak point.

3. the receptor point is a densely populated place, that is, the location where ozone gas can pose a threat to personnel. the main purpose of this is to protect the safety of personnel.

4. For places that need real-time monitoring for 24 hours, fixed online ozone sensors must be installed. Can 24 hours online detection. And according to different occasions need to have diffusion type, pipe type, flow type three kinds of installation. And with high and low two-level alarm, can effectively and safely monitor the ozone concentration, to prevent safety accidents.

5. Although most devices have many leak points and receptor points, these two types of danger points are not always in the same place. For example, a potential leak point may be located at a nearby plant. For the identification of leakage points, refer to all hazardous area classification maps, process safety management and risk management plans, etc.Generally speaking, the installation position of the ozone detector should be close to the potential leakage point. In locations where there is a high possibility of damage or injury to personnel, detection should be carried out even if there is no specific leakage point nearby.

To sum up, it is the installation precautions of the ozone gas detector. For pharmaceutical, medical, disinfection, ozone water separator, ozone disinfection machine and other places or equipment, due to different needs, there will be high and low concentrations of ozone gas. According to the national standard, the ozone concentration in the air shall not be greater than 0.1ppM in the place where there are people. In these places, the uncertainty of ozone gas concentration is an objective potential safety hazard. Therefore, it is necessary to install the ozone gas detector in the relevant device.