Gas detector, as the name implies, is used to detect harmful substances in the gas, help the relevant staff to find out early, and solve these harmful gases in time. Mainly timely calibration and testing, pay attention to its concentration measurement range, pay attention to its use of the environment, and pay attention to its maintenance and so on. In today's article, Xiaobian for the use of gas detector to give you a detailed introduction.

gas detector usage:

1. turn on the power supply of the gas detector, and after the detector completes self-check and preheating to enter the detection state, place the probe in the area of the gas concentration to be detected.

2. the gas detector shall carry out safety confirmation. after confirming that there is no potential safety hazard, it shall enter the working face for detection. When the detection instrument alarm, should be promptly withdrawn from the working face, and forced ventilation for more than half an hour, and then tested. The inspection personnel must write the inspection results of the operation site on the confirmation sheet and take full responsibility for the accuracy of the inspection data.

3. After testing, confirm to turn over the warning board according to regulations.

4. When the gas detector battery is low, it means that the battery is almost dead. Turn off the power in time and use the charger to charge the battery. Each charge is 10-14 hours.

when using the gas detector, you should also pay attention to the surrounding environment, because some products may be installed outdoors for a long time, and the bad weather conditions are also relatively bad, so after using for a period of time, there may be some dust outside the product, or there may be some damage, at this time, the necessary cleaning and maintenance should be carried out on the products installed outdoors for a long time, so that the products can be used outdoors for a long time.