Now, because the oxygen concentration is too high or too low caused by a variety of accidents, have fully proved the necessity of installing oxygen detector. Otherwise, once the oxygen concentration in the environment is too high or too low, in the absence of an oxygen detector, it is very easy to cause various accidents, thus causing danger. Therefore, in the basement, garage, oxygen rich environment, smelting process, chemical industry, national defense industry and other places, should be installed oxygen detector to monitor oxygen concentration at any time. Do you know how to install the oxygen detector ? The following is a brief introduction by yi yun Tian:

1. Installation location of oxygen detector:

According to the on-site environment, select the installation location specifically, just fix the oxygen detector at the specified installation location.

2. Installation location of oxygen detector:

Since oxygen is denser than air, the oxygen detector should be installed about 30cm from the floor.

3. Installation and routing of oxygen detector:

After fixing the oxygen detection detector, you need to connect the power cord, first set the arranged circuit, and then fix the laying. Optional 4-20mA, RS485, HART protocol signal output, and realize in any level, secondary switch output mode, select greater than or less than the set value alarm function. At the same time, you can also choose an external explosion-proof sound and light alarm, which can realize the warning effect of sound alarm and light alarm beyond the alarm point, so as to ensure that the oxygen detector can accurately measure the concentration of toxic gas and give an alarm according to the preset alarm setting value.

4. Installation and debugging of oxygen detector:

If the oxygen detector is wall-mounted, it only needs to be hung 160cm from the ground for easy viewing at any time. After installing the host of the oxygen detector, carry out strict debugging, and you can also test the oxygen detector to see if the reaction between itself and the host of the oxygen detector is normal.

In summary, it is the installation method of the oxygen detector.Under normal circumstances, the oxygen detector has its corresponding installation method. During the installation process, you must carefully watch the relevant instructions. If you want to know more about the oxygen detector, you can come to Yiyuntian for consultation. We have professional personnel to answer for you.