Because ammonia is both combustible and toxic, we must use ammonia alarm to detect the concentration change of ammonia in real time in some places where ammonia may exist, so as to ensure the safety of operation. However, in the process of using the ammonia alarm, in order to ensure its service life and accurate detection, we need to do a good job of maintenance. So do you know how to do a good job in the maintenance of ammonia alarm ? The following is a brief introduction by Yiyuntian:

ammonia alarm should be maintained in the following aspects:

1. ammonia alarm will accumulate a lot of dust for a long time. if it is not removed, it will seriously affect the use and sensitivity of ammonia alarm. therefore, in order to use the alarm normally, we need to remove the dust on it regularly.

2. we should regularly check whether the ammonia alarm is affected by water and moisture, so as to prevent it from happening.

3. When we clean the ammonia alarm, do not wipe the ammonia alarm with detergent or solvent. Because these liquids contain a large amount of chemicals, it can cause permanent damage to our ammonia alarms or transient contamination of the sensor head.

4. regularly check the power-on of ammonia alarm. when it is found that there are flashover, smoke, explosion, peculiar smell, etc., shut down immediately to prevent damage to the instrument due to short circuit and prolong the service life of the instrument.

To sum up, it is some aspects that should be done well in the maintenance of ammonia alarm. By doing a good job in the maintenance of the ammonia alarm, we can not only ensure the accuracy of its detection, but also effectively extend the service life of the ammonia alarm to a certain extent, so that it can accompany us longer.